рефераты конспекты курсовые дипломные лекции шпоры

Реферат Курсовая Конспект

General

General - раздел Компьютеры, AIR TRAFFIC CONTROL SYSTEM The Atc Coax Switches Get Power Through The Atc Ant Switch Circuit Breaker. W...

The ATC coax switches get power through the ATC ANT SWITCH circuit breaker. When you select ATC transponder 1 on the ATC/TCAS control panel, the ATC coax switches do not energize and the antennas connect to ATC transponder 1. When you select ATC transponder 2, the ATC/TCAS control panel sends a discrete ground to the ATC coax switches. This energizes the coax switches and connects the top and bottom antennas to ATC transponder 2.

 

 

 

– Конец работы –

Эта тема принадлежит разделу:

AIR TRAFFIC CONTROL SYSTEM

AIR TRAFFIC CONTROL SYSTEM General The ATC transponder also replies to mode S interrogations... ATC SYSTEM COMPONENT LOCATION... Flight Compartment...

Если Вам нужно дополнительный материал на эту тему, или Вы не нашли то, что искали, рекомендуем воспользоваться поиском по нашей базе работ: General

Что будем делать с полученным материалом:

Если этот материал оказался полезным ля Вас, Вы можете сохранить его на свою страничку в социальных сетях:

Все темы данного раздела:

General
The air traffic control (ATC) ground stations interrogate the airborne ATC system. The ATC transponder replies to the interrogations in the form of coded information that the ground station uses.

Abbreviations and Acronymns
· abs - absolute · abv - above · ADIRS - air data inertial reference system · ADIRU - air data inertial reference unit · AD - air data · ADR - air data

General Description
These are the components of the ATC system: · Top antenna · Bottom antenna · ATC coaxial switch (2) · ATC/TCAS control panel · ATC transponder (2).

Air Data
The air data inertial reference units (ADIRU) send air data to the ATC transponders. ATC transponder 1 gets air data at AD input 1 from the left ADIRU air data reference (ADR) bus 4. The l

Program Pins
Each ATC transponder has these program pins: · Airplane mode S address · Source destination identifier (SDI) · Maximum true airspeed. There are 24 airplane addre

General
The ATC transponders, TCAS, and the DME interrogators operate in the same frequency band. There is a suppression interface between these units. This prevents damage to the receiver circuits during

Front Panel Indications
The test switch starts a self-test. The light emitting diode (LED) status indicators on the front panel show for these conditions: · LRU STATUS (green), if there are no LRU failur

General
The ATC coax switches connect the active ATC transponder to the top and bottom ATC antennas. These are the electrical connector inputs: · ATC antenna switch circuit breaker

Transmit
The central processor unit (CPU) controls the transponder to reply to a mode A, mode C, or mode S interrogation. The mode format circuits use the identity code, airplane altitude and the unique 24-

Test From the Front Panel
Push and release the test switch. All front panel light emitting diode (LED) status indicators turn red for two seconds. After two seconds, the LRU STATUS turns green and the other LEDs remain red.

Хотите получать на электронную почту самые свежие новости?
Education Insider Sample
Подпишитесь на Нашу рассылку
Наша политика приватности обеспечивает 100% безопасность и анонимность Ваших E-Mail
Реклама
Соответствующий теме материал
  • Похожее
  • Популярное
  • Облако тегов
  • Здесь
  • Временно
  • Пусто
Теги