рефераты конспекты курсовые дипломные лекции шпоры

Реферат Курсовая Конспект

Audio Outputs

Audio Outputs - раздел Информатика, MARKER BEACON SYSTEM These Are The Marker Beacon Audio Outputs: · Outer Marker (Om) Is 40...

These are the marker beacon audio outputs:

· Outer marker (OM) is 400 Hz, continuous dashes (- - - -)

· Middle marker (MM) is 1300 Hz, alternate dots and dashes (-.-.-.-.-)

· Inner marker (IM) is 3000 Hz, continuous dots (......)

· Backcourse marker is 3000 Hz, continuous paired dots (.. .. .. ..)

· Airways marker is 3000 Hz with the morse code. identifier for that station.

 

 

– Конец работы –

Эта тема принадлежит разделу:

MARKER BEACON SYSTEM

General... The marker beacon system supplies visual and aural indications when the... GENERAL DESCRIPTION...

Если Вам нужно дополнительный материал на эту тему, или Вы не нашли то, что искали, рекомендуем воспользоваться поиском по нашей базе работ: Audio Outputs

Что будем делать с полученным материалом:

Если этот материал оказался полезным ля Вас, Вы можете сохранить его на свою страничку в социальных сетях:

Все темы данного раздела:

Abbreviations and Acronyms
· A/P - autopilot · AC - alternating current · ACP - audio control panel · ALT - alternate · AMP - amplifier · B - both · BITE - built-in test

Operation
The marker beacon antenna receives the marker beacon signals. The signals go to the VOR/MB receiver 1. The VOR/MB receiver 1 supplies this data: · Marker beacon audio to the remote electro

Marker Beacon Signal
The marker beacon antenna receives the 75 MHz signal and sends it to a 75 MHz filter in the VOR/marker beacon (VOR/MB) receiver 1. This filter tunes and rejects unwanted signals. The output goes to

Monitor and Test
The test switch starts a test of the VOR/MB receiver. The built-in test equipment (BITE) circuits do a test of the VOR/MB receiver. The test results show on the common display, light emitting diode

Operation
When you push the test switch, the receiver does a check of the internal receiver operation and the interface with the NAV control panel. The test takes 48 seconds. This is the test sequence that s

Operation
To do a test of the VOR/MB receiver 1, select a VOR frequency and push the test switch on the front panel of the navigation control panel. FT shows for common display system indications. You must s

Хотите получать на электронную почту самые свежие новости?
Education Insider Sample
Подпишитесь на Нашу рассылку
Наша политика приватности обеспечивает 100% безопасность и анонимность Ваших E-Mail
Реклама
Соответствующий теме материал
  • Похожее
  • Популярное
  • Облако тегов
  • Здесь
  • Временно
  • Пусто
Теги